Savina and Tressanna working on the A/C ducting.

I finally got it done. The A/C is all hooked up and running. I installed the control panel shown below and connected the electrical. Savina shows the A/C working.

With the help of Henry we were able to carry the A/C unit up to the roof and place it over the opening. Now I need to connect the electrical connections, theRead More…

I purchased the A/C unit from Chucks RV in Mead, WA. It is a 13,500 btu unit. It has a smaller footprint and is a little lighter than the Coleman unit theyRead More…

I cut the 14 1/4″ x 14 1/4″ hole in the roof of the van. It is square and ready to accept the A/C unit. Before I can install it I have toRead More…

I finally got the WFCO 7535 power center installed. I put it in a metal box and then mounted a 120 volt plug on top. I pulled some wire for 12 voltRead More…

Rick Suhr build some reflectix insulation material  wheel well booties to cover up the sticky butyl rubber sound deadening material. They look very nice and are held together with Velcro.

I purchased a Dometic Brisk Air 2 13,500 btu A/C unit. I’ll cut the hole tomorrow and install it. I already ran electric behind the panels but I’ll need to build aRead More…

Rick Suhr helped me again, it sure is easier to put the panels up with help. Rick did most of the work putting this panel up.